1⁄35Building the Beast!
building the beast - part one
Andrea Miniatures 1/32 Type VII-C U-boatBack in April of this year I acquired possession of Andrea Miniatures 1/32 U-boat. The gentleman who owned it bought for a lot of money, approximately US$2000.00. I’m not sure when he bought his model, but the same kit today will cost about US$2500.00 thru Squadron Mail Order. The original owner quickly determined that the dexterity in his fingers wasn’t up to the task of such an undertaking. He put the U-boat up for sale for US$400. I was initially going to buy it, but I determined that the money would be better spent on my Harley instead. So the option of buying was out. I contacted the seller/owner and asked if he would be willing to let me build it for him, so he wouldn’t be out all of that money. He agreed and we settled on a fair price for him and I carted the huge chunk of resin home in the bed of my truck.
i need space!
Once I got the sub home, I did a quick assessment of what it was going to take to build this thing. The first thing that came to mind was room; lots and lots of room. My workshop at the time was 11’x17’ with two display cases and a lot of models. It would have to do. I pulled out my trusty Black & Decker Workmate and clamped the hull halves together for some dry runs. Everything looked okay thus far. I cut out the photo etch deck plates, all 2 pounds worth of them and test fit them as well. Again everything looked good. After removing the photo etch plates and setting them aside, I set to work on joining the hull halves together. The owner had attempted to glue them at some point using either super glue or epoxy. I wasn’t able to determine which. The glue had run out and along the bottom of the hull, and completely ruined all the surrounding detail.
let the works begin
I marked all of these damaged areas with a black Sharpie marker. I then used a Makita palm sander and began the task of removing the damaged areas, while trying to save as much detail as I could. For the most part, I was successful. What detail was lost, was on the bottom of the hull and wouldn’t be seen. I planned on replacing it with styrene bits and pieces anyway. Now that the damaged areas were cleaned, I cleaned the mating surfaces between the hull halves, and then clamped them together. I now noticed that the left and right halves didn’t match exactly. One was actually shorter than the other. Not much, but shorter none the less. I decided to align then based off of the rear of the boat. I did so and started gluing the halves. I quickly ran out of glue after only a foot or so of progress. What to do?
Copyright ©2019 by Matthew Quiroz. Images also by copyright holder unless otherwise noted. The views and opinions expressed herein are solely the views and opinions of the authors and/or contributors to this Web site and do not necessarily represent the views and/or opinions of AeroScale, KitMaker Network, or Silver Star Enterrpises. Images also by copyright holder unless otherwise noted. Opinions expressed are those of the author(s) and not necessarily those of AeroScale. All rights reserved. Originally published on: 2006-01-05 00:00:00. Unique Reads: 23482